The LHC3500 is just one of the ways Winona Van Norman can increase your profits. Why spend twice the money, and take up twice the floor space with two machines when you can use just one? You can go from honing cylinders to honing main bearing bores in less than five minutes.
Hone V8, V6, and inline blocks up to 42" long.
Remove stock fast. 1 Hp gear reduction drive motor and friction feed hone head, allows the operator to remove stock fast.
Get round cylinders everytime without stopping to gauge.
Stroke speed control knob and air/oil stroke system achieve a smooth consistant crosshatch angle that is infinitely variable.
Positive bottom stop is adjustable and prevents hone head from hitting main webs.
Up front carriage traverse handle allows operator to quickly and easily position hone head over cylinder.
Convenient dwell button on front control panel allows operator to dwell hone head anywhere in cylinder.
Easy to raise and lower cradle that runs on precision headscrews.
Drain most auto blocks by inverting cradle to 180°.
Clamps go through main bearings to allow torque plates for high performance blocks.
Quick Coupler to switch from honing cylinders to main bearings in seconds.
Line hone travels on precision ground stock and large linear bearings - keep honing straight and accurate.
Convenient sure-lock rollover bar system allows operator to put block at correct angle in seconds.
Line honing done easily and quickly with a 3/4Hp heavy-duty high torque motor.
Honing oil filter system ensures clean oil and consistent surface finish
Dual Mandrel storage tubes.
Drip trays on both ends of machine to keep shop clean.
