Heavy-duty 1/2 Hp motor w/ non-slip Timing Belt and pullys ensure power Honing taking out more material faster.
Liner Bearings for easy slide of head from one cylinder to the next.
All small engines work, "V" and Inline blocks up to 25" long. Also accomodate Singles, Twins, Triples and Fours.
Heavy construction added with the hand free foot controller eliminate the need for vicing the cylinder down while honing.
An 8 gallon oil capacity is used to flood the cylinder while honing which results in better cooling and surface finish. All while keeping your shop floor oil-free.
Fully adjustable stroke speed and use of rigid AN112 hone head achieves superior accuracy and bore geometry.
Easy to set-up and be productive thanks to a wide range of honing abrasives.
Exterior cradle clamp make it easy to roll cylinders from bank to bank.
Electronic Limit switches - easiest and fastest in the industry. Stroke length in seconds.
Top side slide bar - better rigidity and less movement means more accuracy.
Drive Motor 1/2 HP
Electrical 110 Volt required
Stroke Adjustable to 7" (254 mm)
Honing Range 2.6" - 5.6" (66 - 142 mm)
Air 110 PSI 3 CFM
Machine Weight 635 lbs.
